Digi Hubport Series, Руководство по установке

Страница: 9 / 10

Hardware specifications and device LEDs Hubport/SuperSpeed
Hubport® USB Hub Installation Guide 9
Power requirements
The Hubport/14 uses a single 120/230 VAC 50/60 Hz power input through the rear IEC 60320 inlet.
The maximum power requirement of the Hubport/14 is 40 W.
WARNING! HAZARDOUS VOLTAGE(Hubport/14 only). This unit contains an internal power
supply. Before servicing the device, make sure the power is disconnected.
Hardware interface features
The unit provides a single upstream (standard B-type receptacle) and 14 downstream (standard A-
type receptacles) USB 2.0 compliant ports. The unit will attach to the upstream device as a full/high-
speed hub. The downstream ports support low-speed, full-speed and high-speed downstream devices.
Each downstream facing port provides a green LED status indicator. Color definitions are as follows:
Off Port out of operation.
Green Port fully operational.
Blinking off/green Port needs attention.
The unit features a green system status LED with the following color definitions:
Off Unit out of operation.
Green Unit is powered.
Hubport/SuperSpeed
Dimensions
Length: 2.61 in (6.63 cm)
Width: 3.00 in (7.62 cm)
Height: 1.00 in (2.54 cm)
Weight: 6.20 oz. (175.80 g)
Environmental
Operating temperature: -40° F to 158° F (-40° C to 70° C)
Relative humidity: 0% to 95% (non-condensing)
Power requirements
The Hubport/SuperSpeed requires 6 V to 28 VDC. The maximum power requirement of the
Hubport/SuperSpeed is 35 W.
Hardware interface features
The unit provides a single upstream (standard B-type receptacle) and 7 downstream (standard A-type
receptacles) USB 3.0 compliant ports. The unit will attach to the upstream device as a
full/high/SuperSpeed hub. The downstream ports support full-speed, high-speed, and SuperSpeed
(Gen 1) downstream devices.
Each downstream facing port provides a dual LED status indicator. Color definitions are as follows: