Chapter 2
2-4
MIL-3000FTX Series of FastPort Print Servers
I
N
S
T
A
L
L
A
T
I
O
N
Figure 2-2. Rear Panel of MIL-3100FTX
Note:
The MIL-3200FTX will have two parallel ports. The MIL-3310FTX will
have three parallel ports.
8. Connect the power supply: Select the proper voltage for
the specific country.
a. Place the unit near the printer.
b. Plug the power connector into the receptacle marked
Power
on the rear of the unit.
9. Verify normal boot-up. The unit performs POST (power-
on self-test) at start-up and tries to resolve its IP addresses:
– If the IP address is set, the
SYS
LED blinks once per
second.
– If the IP address is not set, the
SYS
LED blinks five times
per second until the address is set either manually or by
using
RARP
,
BOOTP
, or
DHCP
.
FastPort should now be functioning on the network. Consult
the
FastPort User’s Guide
to continue installation for a specific
client computer.
PARALLEL 1
POWER
Rear
