Digi Digi CM 16, Руководство пользователя

Страница: 90 / 190

Microsoft SAC support Setup the Windows Server 2003 port
Digi CM User Guide 90
2 Cable the console port on the Windows Server 2003 to the Digi CM unit’s port. See the
information in About serial port cabling .
3 Set up the Digi CM unit for SAC support. See Setup the Digi CM Unit for SAC support .
Setup the Windows Server 2003 port
1 Sign on to the Windows Server 2003 as the administrator.
2 Access the command line.
3 Use the bootcfg command to redirect console traffic to the correct COM port. The following is the
command syntax and an example. See the Microsoft documentation for additional information
on the SAC feature.
Command syntax
bootcfg /ems on /port com# /id # / baud 115200
where:
▪
com# is the COM port to which console traffic will be redirected.
▪
# is the is the number of the boot entry.
▪
The port speed is set to the recommended rate (although you can use any rate supported by
Windows Server 2003).
Command example
In this example, console output is redirected to COM 2, the boot entry is specified as 1, and the port
speed set to 115200.
bootcfg /ems on /port com2 /id 1 /baud 115200
Setup the Digi CM Unit for SAC support
To set up a serial port to provide access to the Windows Server 2003 console port, do the following:
1 Access the web interface.
2 Choose Serial port > Configuration .
3 Choose a port.
4 Choose Host mode configuration .
The Host mode configuration page appears.
5 Set the Host mode to Console server and the Type of console server to MS SAC -English (or
Japanese) console as shown in the following figure.