SETTING THE TRANSMITTER CODE SWITCH – MODEL’S 5020 & 5022
On the transmitter the entire front lower half of the case ( “ the battery hatch” ) is
removeable. Use a coin or the curved end of the visor clip to disengage the lower half of
the transmitter front. This will expose both the code switch and the battery compartment
Once you have done this, locate the code switch and set code switch positions 1 through
9 to your personal code scheme
( THE 10
TH
POSITION SWITCH MUST BE SET IN
THE CLOSED POSITION “ON” )
. We strongly urge that several coding schemes be
avoided: ALL ON; 2,4,6,8,10, ON. These positions are similar to our or other
manufacturers test positions, or are frequently used.
SETTING RECEIVER #1 (WORKS WITH LEFT BUTTON ON TRANSMITTER)
Use your finger to slide the “code switch hatch” from the receiver for access to the code
switch. Set the receiver code switch positions 1 through 9 to match the transmitter code
switch.
Then make sure that the 10
th
position switch on receiver #1 is set in the
closed position “ON”
. The left button on the transmitter should now operate this
receiver.
Once the codes have been set, check operation and reinsert the hatches.
SETTING RECEIVER #2 (WORKS WITH RIGHT BUTTON ON TRANSMITTER)
Use your finger to slide the “code switch hatch” from the receiver for access to the code
switch. Set the receiver code switch positions 1 through 9 to match the transmitter code
switch.
Then make sure that the 10
th
position switch on receiver #1 is set in the open
position “OFF”
. The right button on the transmitter should now operate this receiver.
Once the codes have been set, check operation and reinsert the hatches.
CAUTION
: Any changes or modifications in intentional or unintentional radiators which
are not expressly approved by Digi-Code Inc. could void the users authority to operate this
equipment. This applies to intentional and intentional radiators certified per part 15 of the
FCC rules and regulations.
DIGI-CODE, INC.
307 ROBBINS DR.
•
TROY, MICHIGAN 48083
(248) 589-3645
03/01/00
