DIEL MT 200 C, Инструкция по установке и эксплуатации, Страница: 14 / 48

ENGLISH
- 14 -
PROGRAMMING
Push and hold the buttons "UP" and "DOWN for programming menù.
On the display appears finally the letter "F" which allows to fasten the state of the
monitor system:
•
0: three probes without control of the cooling fans.
• 1: four probes with control of the cooling fans.
• 2: four probes without control of the cooling fans.
• 3: three probes with control of the cooling fans.
• 4: advanced programming menu.
Default configurations: P=140,A=160,L=90,H=100,F=0.
Modify it pressing buttons UP/DOWN and confirm by <ENTER>.
In case of choice F=4 jump to menu: ADVANCED MENU PROGRAMMING, in other
case continue here.
On the display appears the letter "P" (Pre-alarm) and the set temperature from the last
programming.
The pre-alarm temperature is set through UP/DOWN buttons.
After setting the pre-alarm temperature push <ENTER>.
The letter "A" (Alarm) appears together with the set temperature of the last
programming. If the new pre-alarm temperature is higher than old alarm, the device
propose a new pre-alarm temperature more 1 degree.
Modify it pressing buttons UP/DOWN and confirm by <ENTER>.
In case of choice F=0 or F=2 the programming procedure is finished, in case of
configuration F=1 or F=3, continue as follows.
Now on the display appears the letter "L". for the choice of the lowest temperature
under which the fan switches off.
Modify it pressing buttons UP/DOWN and confirm by <ENTER>.
The letter "H" appears to choose the maximum temperature over which the fan
switches on.
Modify it pressing buttons UP/DOWN and confirm by <ENTER>.
Soon out of programming procedure the device executes a LAMP/TEST.
System is prearranged in automatic way and visualises so the maximum measured
temperature and the relative channel.