1.
0
0
1
1
2
3
4
5
6
7
8
9
0
＃
＊
User
＇
s Manual for Private Container with LCD and Electronic Combination Lock
Applies to Model JJB-23L1
B-23L1
B-23L1-1
G1-912N、G1-913N
and JJB-23L1-1
Please read this User
＇
s Manual carefully before using this product. Its factory code is: 1
、
5
、
9.
F i r s t T i m e O p e r a t i o n
Open the door of the private container (See
＂
Using the Override Key
＂
in Page 2). Take out the 4AA batteries
from the Private Container, and install it in its compartment. (See
＂
To Replace the Batteries
＂
in Page 2.)
T o O p e n
Enter the code followed by pressing the
＂
＃
＂
button and the prompt
＂
＂
will be displayed on the LCD
screen. Within 5 seconds, turn the knob clockwise to open the door of Private Container.
Note: The factory code 1
、
5
、
9 should be used to open the door of the Private Container for the first
time. Please program your new user code after the first operation. Refer to
＂
To Program Your
User Code
＂
for details.
The interval between two pressing button should not exceed 20 seconds, otherwise this operation
will become invalid.
T o C l o s e
Close the door of Private Container, then turn the knob counterclockwise , and the door will be locked.
T o P r o g r a m Y o u r U s e r C o d e
Locate the battery compartment in the door back. Remove its cover according to Figure A. Press the user code
changing button. The prompt
＂
＂
will be displayed on the LCD screen with two beeps to indicate that it
is in process of changing the user code. (
Please replace the battery compartment cover after completion of
changing the user code.
)
With the door open, enter your new user code (2-8 digits) followed by pressing
＂
＃
＂
button. The LCD screen
will flash your new user code three times and turn off by itself.
New user code has been successfully set up.
Note: Please repeat operating the Private Container
with your new user code according to
＂
To
Open
＂
for several times to confirm that your
new user code can open the door. Then close
the door and turn knob counterclockwise .
Please keep your new user code in a safe place
as the old code becomes invalid now.
User Code Changing Button
Compartment Cover Moving Direction
Figure A
U s i n g t h e O v e r r i d e K e y
override keyhole behind the disk board. Insert the override key (See Figure C) into the hole and turn it clockwise
followed by turning the knob clockwise to open the door of Private Container.
Turn the LCD disk board counterclockwise and remove it from the panel (See Figure B). You will see the
(Please remove the override key in time after operation.)
Note: The override keys are for
emergency use. Please keep
them in a safe place. Do not
place them in this Private
Container.
LCD Disk Board
Override Keyhole
Figure B
Figure C
Shanghai Diebold Security Equipment Co., Ltd.
Add. : 1188 Caobao Rd., Shanghai, 201102, P.R. China
Tel : 86-21-6480 1118 Fax : 86-21-6480 1238
Website: http:// www.diebold.cn
Knob
