Midhage Diatip AB May 2003
5
4
The matrix A1 has three different radii.
Choose which radius is suitable for the
core bit. (Position "D" is only for the 16
mm or 20 mm matrix):
Ø 55-90 mm
A
Ø 90-200 mm
B
Ø > 225 mm
C
Ø > 35 mm
D
See also the red plate on the tool set
The matrix A2 and A3 are for radii >/= 35
mm resp. >/= 45 mm
To change position of the matrix loosen
the handle which locks the matrix and
lower enough for the guide pin on the
bottom of the head to come free
VERY IMPORTANT
Guide
Pin
5
Be sure that the guide pin on the bottom
of the cutter head fits into the hole on top
of the matrix for the new position
6
Tighten the handle clockwise. After the
matrix is secured in position carefully
check that the cutting knife moves freely
into the matrix.
