NOTICE:
Risk of property damage. Failure to do so could cause damage to the
pump.
2.
Turn engine off. See
Engine Owner's Manual
.
NOTICE:
Risk of property damage. NEVER turn the water off with the engine
running.
3.
Turn water source off.
4.
Pull trigger on spray gun to relieve any water pressure in hose or spray gun.
NOTE:
Failure to release system pressure will prevent removal of high pressure
hose from spray gun or pump connection.
5.
See
Storage
section in this manual for proper storage procedures.
MAINTENANCE
WARNING: Risk of burn hazard. When performing maintenance, you may
be exposed to hot surfaces, water pressure or moving parts that can cause
serious injury or death.
WARNING: Risk of fire hazard. Always disconnect, spark plug wire,
let the engine cool and release all water pressure before performing any
maintenance or repair. The engine contains flammable fuel. Do not smoke or
work near open flames while performing maintenance.
To ensure efficient operation and longer life of your pressure washer, a routine
maintenance schedule should be prepared and followed. If the pressure washer is
used in unusual conditions, such as high-temperatures or dusty conditions, more
fre quent maintenance checks will be required.
ENGINE
Consult the
Engine Owner's Manual
for the man u fac tur er's recommendations
for any and all maintenance.
NOTE:
The engine drain plug is located at the rear of
the unit.
pUMp (FIG. 14)
NOTE:
The Pump was filled with oil at the factory. The preferred oil is SAE
15W-40. Change the pump oil after the first 50 hours of operation and every 100
hours thereafter, or every 3 months.
TO CHECk OIL
The oil level should come to the dot in the middle of the sight glass (AA).
HOW TO CHANGE pUMp OIL
1.
Loosen pump oil fill plug (BB).
2.
Place a container under the pump oil drain
14
BB
AA
CC
plug (CC).
3.
Remove pump oil drain plug.
4.
After oil is drained, replace pump oil drain
plug. Tighten securely.
5.
Refill pump using
an SAE 15W-40 oil.
6.
Replace pump oil fill plug and tighten securely.
If there is a problem with the pump contact us at
-
1
8
-
Diamond Products
Operator's Manual
