Diamond KCGD1/AS, Руководство пользователя, Страница: 7 / 10

7
IV. INSTRUCTION FOR INSTALLATION
1.
Legal and technical regulations and directives
When installing this oven, you must comply with the following:
• By-laws currently in effect.
•
Local building and fire-prevention regulations.
• Regulations regarding electrical systems.
•
Accident-prevention regulations currently in effect.
2. Place of installation
The appliance must be installed in well aired rooms.
3. Positioning
Unpack the hood and carefully remove the protective film.
Should any glue remain on the oven surface, remove with a suitable, non-corrosive solvent.
Check that all the component parts of the hood are in good condition and are not faulty or broken,
otherwise inform the manufacturer in order to be told the procedure to follow.
Per il posizionamento della cappa procedere come segue:
1. Fissare le staffe di sostegno al forno mediante le viti autofilettanti in dotazione.
2. Posizionare la cappa sopra le staffe e inserire i due tubi di sostegno anteriori nelle boccole situate
lateralmente alla camera di aspirazione appoggiandoli con le apposite ghiere sul coperchio del forno.
3. Collegare lo sfiato vapori del forno alla ghiera posta sulla parte inferiore del condotto di aspirazione.
4. Connect the aspirator to the flue or to whatever outlet to the exterior is present, using a pipe D.150 that
must be provided by the installer.
N.B. The length and the bends of the steam/vapour outlet pipe affect the suction rate of the aspirator.
4. Electrical connection
Electrical connections must be performed only by a qualified electrician.
The technical data plate located on the back of the hood contains all the information required for proper
electrical connection.
The appliance must be connected to the mains using a H05 RN-F type power cord.
Connect the hood to earth and insert it into the unipotential circuit; the terminal for this purpose is to be
found at the rear of the oven and is marked by the international symbol .
Connect the appliance to the electricity supply through a double-pole differential magnetothermal circuit
breaker having a contact separation of at least 3 mm on both poles, which is readily accessible and near to
the appliance.
The manufacturer cannot be held liable in the event of failure to comply with the above.
5. Appliance Check up
To start off the hood, follow the instructions contained in the paragraph “ Switch on, parameters setting,
switch off ”.
Check the correct working of all electrical parts, explaining to the user how to best operate the appliance
and carry out all ordinary maintenance and cleaning.
GB