12
CHAP. 7 - MAINTENANCE
7.1 - GENERAL FEATURES
Before starting any maintenance activity it is necessary:
a) to disconnect the power supply plug from the socket to isolate the CUTTER
from the electric circuit completely.
b) if the CUTTER is a vv model, to set the speed dial knob to the “0” position.
7.2 - BELT
The belt does not need to be adjusted. Generally it must be replaced after 3/4
years; in this case, please call the “SERVICE CENTRE”.
7.3 - FEET
Feet might deteriorate and lose elasticity; consequently the stability of the
machine might be reduced.
In this case they must be replaced.
7.4 - POWER SUPPLY CORD
Periodically check whether the power supply cord is worn-out and, if this is the
case, please call the “SERVICE CENTRE” to have it replaced.
7.5 - BLADES
Check that blades have not lose more than 5 mm of thickness after sharpening.
Call the “SERVICE CENTRE” to have them replaced.
7.6 - KEYBOARD LABEL
The label of the keyboard could be marked and/or holed. In this case, please call
the “SERVICE CENTRE” to have it replaced.
CHAP. 8 - DISPOSAL OF THE MACHINE
8.1 - PUTTING THE MACHINE OUT OF SERVICE
If for some reason, you decide to put the machine out of service, make sure
nobody can use it:
disconnect it from the mains and eliminate the electrical
connections.
8.2 - DISPOSAL OF THE MACHINE
When the machine is out of service, it can be eliminated. To dismantle the
machine contact a Specialized Centre, paying attention to the different materials
used (
see chap. 1 par. 3.2
).
