Diamond 503.136.201, Инструкция по установке, эксплуатации и обслуживанию

Страница: 10 / 25

27
-
The flame control uses a special electrode to ensure
burner/s work properly.
-
Should the burner/s accidently go out or
malfunction the system signals an error, the
corresponding light on the control panel lights.
-
The gas is shut off and the cooking session is
temporarily interrupted so that the operator can
intervene.
-
In order to reset press the lighted button for 1
second. The flame control will automatically
perform three attempts to reset before signaling an
error.
12. USING THE PROGRAMMABLE OVEN
The appliance has been designed to cook food in
closed premises and must only be used for this
purpose: any other use must, be avoided and
considered improper & dangerous.
Before cooking, we recommend pre-heating the
oven at a temperature of about 20/25% higher than
that required.
Once plugged in, the oven is in “stand-by” condition,
it shows the label "OFF"
The oven control panel is equipped with a knob "M"
to perform the insertion and modification of the
functioning parameters of the appliance.
Such knob can also be pressed to select a function or
confirm a certain parameter.
The knob acts on a digital encoder and, therefore, is
in continuous rotation. The parameters adjusted by
the encoder vary clockwise increasingly.
Cooking temperatures range from a minimum
temperature of 0° to 280° C.
I tempi di cottura impostabili variano da infinito a
240min.
By default the oven set the fan speed to maximum.
HUMIDIFIER
You can set the percentage of humidity in the
chamber
during a cooking cycle.
the value can be set at the beginning of the cycle or
during the execution of the cycle.
- Press button T9;
- Turn knob M to the value to be set;
- Press the knob to confirm the value.
HUMIDITY DRAINIG VALVE
The humidity draining valve has the task of expelling
humidity formed inside the cooking chamber during
the cooking.
Even with the valve closed, there is no risk of
overpressures inside cooking compartment as
because over-pressure is controlled by the drain.
At the end of the cooking cycle the valve remains in
the position it was in at that moment.
The opening or closing of the humidity discharge
valve is controlled by pressing the T8 key.
The valve opening is signalled by the led L3
- Led on: VALVE OPEN
- Led off: VALVE CLOSE
FANS
Pressing the T12 you can change the fan speed
The default speed is set to high,LED 6 on. Pressing
the
T12 switching from high to low speed, L7 on
COOLING
At the end of a cooking cycle the oven has the
possibility
to set a cooling cycle to lower the temperature
inside
the baking chamber
When the oven is in stand-by mode, proceed as
follows:
- Press button T5;
- Press the T13 button to start.
-
The oven starts to cool by spraying water on the
moving
fan (oven door closed) or just using the fan
(oven door open).
-
The cooling cycle is terminated when the
temperature
of the cooking chamber reaches 50 ° C.
CONVECTION COOKING
Once turned on the oven by pressing button T1, D3
display shows the label "ON".
Select convection cooking mode by pressing the T2
button.
D3 display shows the label "CNV"
Display D1 will alternately flash the LED L1 and L2.