4
Installing the Monitor
This monitor is equipped with an autosensing power supply for voltage ranges
100~240V AC, 50~60Hz.
To install the monitor :
1.
Make sure that the system power is turned
off.
2.
Please refer to the instructions below to
connect the signal cable through D-SUB or
BNC.
3.
Connect the power cord to the monitor
and attach it to power source.
4.
Turn on the computer and the monitor.
Connecting the Signal Cable
Your DV17NF provides D-SUB and BNC signal connectors. The D-SUB or BNC signals
can automatically be detected by its microprocessor.
Connecting through D-SUB signal connector
1.
Make sure that the system power is
turned off.
2.
Connect the computer end of the D-
SUB cable to the 15-pin output
connector on the video board of your
computer.
3.
Connect the monitor end of the D-
SUB cable to the D-SUB receptacle on
the back of the monitor.
Содержание DV17NF
Страница 3: ......
