EMX-ESG User Manual Rev A.1
www.diamondsystems.com
Page 8
5. CONNECTOR AND JUMPER LIST
5.1 Connector List
The following table summarizes the functions of the EMX-
ESG’s interface connectors. Refer to the Figure 2 for
connector and jumper locations. Signal functions relating to all of EMX-
ESG’s interface connectors are discussed
in detail in Section 6 of this document. Other connectors and jumper blocks on the board are reserved for
Diamond Systems
’ use only.
.
Connector
Function
J1
EMX Top
J2
EMX Bottom (not shown on drawing)
J3
GPIO
J4, J5, J6
Serial Ports
J7, J8
Ethernet Ports
J9
Ethernet LEDs
U10
GPS
5.2 Jumper List
See Section 7 for information on configuring jumpers.
Jumper
Function
J10
Serial Port Termination jumper
J11
Address and Protocol jumper
As a custom assembly option, EMX-ESG was designed with 0-ohm resistors that may be installed in place of the
jumpers for a more rugged assembly.
