CME-Atom User Manual 1.2
www.diamondsystems.com
Page 12
3.3
Booting the System
Power-up the display, then power-up the system power supply.
The CME-Atom module should begin its boot-up sequence immediately, as evidenced by BIOS messages on the
connected display. You can use the BIOS Setup utility and install an operating system on the boot drive just as
you would on a normal desktop PC.
3.4
BIOS Setup Utility
The BIOS Setup utility program is used for specifying the system configurations and settings. The BIOS ROM of
the system stores the Setup utility. When you turn on the computer, the BIOS is immediately activated. The
following menus/options are available:
Main Setup Menu
Advanced Setup Menu
PCI/PnP Setup Menu
Boot Setup Menu
Security Setup Menu
Chipset Setup Menu
Exit
Use the left/right arrow keys to highlight a particular configuration screen from the top menu bar, or use the down
arrow key to access and configure the information in the menus which are described below.
3.4.1
Main Setup Menu
This menu allows you to select configuration options for the following:
System Time
System Date
3.4.2
Advanced Setup Menu
This menu allows you to select configuration options for the following:
CPU Configuration
– Settings for Hardware Prefetcher, Adjacent Cache Line Prefetch, Cache L1 & L2,
Max CPUID Value Limit, Vanderpool Technology, Core Multi-Processing, and
Intel® SpeedStep™ Tech.
Mass Storage Configuration
– Settings for hard drives (Primary/Secondary, Master/Slave).
Floppy Configuration
– Settings for the type of floppy drive installed on the system.
Super IO Configuration
– Settings for Onboard Floppy Controller, Serial Port1 / Port2 Address, Serial
Port2 Mode, Parallel Port Address, Parallel Port Mode, Parallel Port IRQ, Restore on AC Power Loss by
IO.
Hardware Health Configuration
– Settings for System/ CPU Temperature 1, CPU / System Fan Speed,
Vcore (CPU voltage), +5.0V / +3.3V / +12.0V / 5Vsb / VBAT (standby and battery voltage).
ACPI Configuration
– Settings for Suspend mode.
AHCI Configuration
– Settings for AHCI Ports.
APM Configuration
– Settings for Power Management/APM, Video Power Down Mode, Hard Diks Power
Down Mode, Suspend Time Out, Keyboard & PS/2 Mouse, Power Button Mode, Advanced Resume
Event Controls.