diamond mowers Rear Swing Flail, Руководство оператора

Страница: 34 / 52

REAR SWING FLAIL OPERATOR’S MANUAL
SWINGARM
Greasing:
•
Extend out the swing arm to expose
the grease zerks. Rest the flail head
on the ground to relieve pressure
on the swing arm joints before
greasing.
◦
NOTE: It may be necessary to
swing / rotate the swing arm to
expose all of the grease zerks.
•
Grease all of the zerks
(1)(2)(3)(4)(5)
with
#2 lithium based grease every 10
hours or daily until grease appears
around the joints.
•
Inspect all cylinder anchor hardware
for wear or damage and replace as
needed.
Breakaway Spring Tension:
•
Standard spring
(6)
tension is set
with the springs
(6)
at 9” (228mm)
measured from the center of the
outermost coils.
◦
Tighten or loosen the tension
nuts
(7)
to achieve the proper
spring
(6)
dimensions.
◦
NOTE: If more breakaway spring
pressure is desired, tighten the
tension nuts
(7)
until the springs
(6)
measure an additional 1/4” (6mm).
-
Test for satisfactory
performance. Make additional
tension nut
(7)
adjustments in
1/4” (6mm) increments.
CONTINUED ON NEXT PAGE
(3)
(4)
(5)
(2)
(1)
(2) (1)
(3)
(4)
(7)
(5 @4)
(6 @4)
34