©007 Diamond Audio Technologies, LLC
D3 COMPONENT SPEAKER SYSTEMS
Parts List - D342, D352, and D362
(2) D3 Mid-Bass Speakers
(2) D3 Grills w/ Mounting Rings
(2) Mounting Gaskets
(2) D3 12dB Crossovers
(2) D3 Tweeters in Flush Mount Cups
(2) D3 Tweeter Surface Mounting Cups
(1) Mid-Bass Mounting Hardware Kit
(1) Tweeter Mounting Hardware Kit
Tweeter Mounting
When flush or surface mounting tweeters, make
sure desired location can accommodate the
hole sizes and depth required. Mount cup using
provided hardware, flush mount illustration shown
on right. Mount surface cup at desired angle with
provided screws in tweeter mounting kit. Snake
speaker wires through tweeter cup, connect tweeter to wires, and snap tweeter into cup by aligning
the notches. Be careful not to push on the center of the tweeter grill.
Crossover Programming
Each D3 component set comes with a pair of model specific programmable crossovers. Under the clear
cover there are two jumpers, one marked “TWEETER” and one marked “AXIS”. -2 dB tweeter attenua-
tion can be achieved by moving the “TWEETER” jumper to the -2dB position. The default “reference”
position has no attenuation effect on the tweeter or is 0dB. The “AXIS” jumper swaps the tweeter
phase 180 degrees. The default position is “off axis” for mounting in dash boards, doors, and a-pillars.
The “on axis” position is for tweeter positions that fire directly at the listening area like in custom
kick pods.
RAF Outputs
Each D3 Component crossover has a third set of outputs marked “RAF”. This stands for Rear Acoustic
Fill. This output can be used to power an additional speaker off the same channel without affecting
the impedance load on the source unit. This output allows 15-20% of the total power to the extra
speaker and is unfiltered or full range.
