3.5
7
10
14
18
21
24
28
50
off
7MHz TUNING
7MHz = 1249
1200
800
POWER
SD330 CONTROLLER
RESET
DOWN
SDC1
FREQ
GO
UP
1
2
3
4
5
6
7
9
8
To cigar socket
To the SD330 Antenna
SD330 Antenna
(not included)
DIAMOND ANTENNA CORPORATION
Miyata Building, No.15-1,1-chome Sugamo,Toshimaku Tokyo,Japan 170-0002 TEL.03-3947-1411 FAX.03-3944-2981
Home Page http://www.diamond-ant.co.jp
E-mail [email protected]
The included cable
of the SD330
(not included)
core
・
How to use the SDC1
1, Connect it as shown in below. Plug the cigar plug
into a cigar socket.
2, To turn the power switch ON, LED lamp turns on
and the current operation situation is shown on
the display panel.
3, Turn the frequency change dial and set the
operation frequency.
4, When pushing the GO button, the frequency and
“GO HOM POSITION” will be shown in the
display panel and the coil will be moved to the
lowest position. After that, the coil will be moved
to the selected frequency. The frequency and
position count number will be shown at that time.
5, When the coil goes to the selected frequency, the
coil will be stopped automatically. After stopping
the coil, please transmit at less than the output
10W. Adjust the SWR by UP/DOWN buttons.
(Since the antenna’s conditions will be changed
depending on the surrounding condition, weather
and installation place. Please make sure to
check SWR.
6, To keep pushing the UP button, the coil will be
moved to the highest position and be stopped
moving. Since the internal motor will keep truing,
stop pushing the UP button at the earliest. After
that, to push the RESET button and push the GO
button, the coil will be moved to the selected
frequency.
7, If you want to stop the coil during operation, push
the RESET button. The coil will be stopped at the
position.
8, When you want to re-start the UP/DOWN
movement, go back to 3 or push UP/DOWN
buttons. The coil will be moved.
9, When operating 50MHz band, use the optional
element “OPE750”.
●
The SDC1 is not the water proof structure. Do
not get water to the product.
●
Since the inside of the SDC1 is a complicated
electronic circuit, don’t use it where is a strong
magnetic field or high temperature and
humidity.
●
Since the dashboard of the car becomes high
temperature, don’t install the product at the
dashboard.
・
Descriptions and Functions
①
Display panel: The operation situation is shown.
②
Frequency change dial: To change the
operation frequency.
③
GO button: To start the operation.
④
UP button: To go the coil up. (To tune lower
frequency)
⑤
DOWN button: To go the coil down. (To tune
higher frequency)
⑥
RESET button: To stop the coil during moving
the coil.
⑦
Power switch: To turn ON/OFF.
⑧
Cigar plug: To connect with a cigar socket of a
car and to take power supply.
⑨
Terminal for connection with the SD330: (The
terminal is different depending on the
production time. Please connect with a suitable
one.
・
Wiring and Connection
