<<Attention>>
●
Do not install the product where is got the direct
rays of the sun. Do not install the product near
the jet of the air conditioner. It may cause to
have a fire, transform, discolor or damage.
●
Do not wipe it off with thinner or benzene. If it
becomes too dirty, wipe it off the neuter
detergent.
●
Do not install the product where there is much
moisture or dust. It may cause to have a fire,
generate heat, electrify or damage.
●
For the safety, be sure to cut off the power
supply when it is not used.
●
Do not put something heavy on the product.
●
Use the product under rated specification only.
●
Do not use the product when driving a car.
Serious accidents could have been happened.
・
Specification
Frequency: 3.5/7/10/14/18/21/24
/28(29)/50MHz Band
Operation time:
3.5MHz
→
HOM
→
3.5MHz approx. 160 sec.
7MHz
→
HOM
→
7MHz approx. 50 sec.
14MHz
→
HOM
→
14MHz approx. 20 sec.
*HOM –Operation standard position
(Lowest position of the coil)
Power supply voltage & current:
DC12V (9-14.5V) 200mA
Dimensions: 85(W)x 120(D)x 32(H)mm
Weight: 380g
<<Note>>
●
Power supply voltage of the SDC1 is DC12V
(9-14.5V usable). Please use it with the
prescribed voltage.
●
If the polarity of the power supply is wrong, the
power supply is not going to turn ON because of
a safety circuit.
●
The fuse of the cigar plug is 2A. When changing
the plugs, please use the prescribed standard
one.
●
Do not push more than two buttons at the same
time. Do not tune the frequency change dial
during moving the coil. It may cause
malfunction and the antenna may be damaged.
●
The controller cannot be auto-tuning. The fine
tuning by manual operation is required.
SDC1
Operation Instructions
SD1 is a tuning controller for the SD330 screw
driver antenna.
To use the product properly, read these
instructions thoroughly before using it. Keep this
manual carefully at hand for later use. The manual
will be changed in the future without advance
notice.
<<Warning>>
●
Do not use the product under unusual
conditions. Do not use the product when
unusual conditions happen such as smoking,
unusual smell or sound. Keeping using the
product under those situations may cause to
electrify or damage. Ask the dealer to repair it.
Do not repair it by yourself because it is
dangerous.
●
Do not overhaul or reconstruct the product. It
may cause to have a fire, electrify or damage.
●
Do not put wire, metal or substance into the
product. It may cause to have a fire, electrify or
damage.
●
Do not use the product at the place where
inflammability gas is generated. It may cause to
have a fire or explode.
●
Do not use the product except for the
specification of the operation instructions. It
may cause to have a fire, or electrify.
●
Do not damage, process, bend, twist or put the
power supply cord. Do not put something heavy
on the product or heat it up. Breaking the cord
may cause to have a fire, electrify or damage.
●
Do not use the product when cigarette lighter is
inserted loosely. It may cause to have a fire,
electrify or damage.
●
Do not touch the power supply plug or the
product with wet hands.
●
Do not use the product where is easily
reachable by babies and children. It may cause
to electrify or do themselves an injury.
●
Do not soak the product in water. Do not get wet
the product. It may cause to have a fire, electrify
or damage.
●
Do not drop the product. Do not give them big
impact.
Tuning Controller for SD330
