FUNCTIONAL DESCRIPTION
n
Operation Instructions:
Wheel Guard
Aim the convex end of the wheel
guard to the slot mouth of the
front cover, and then rotate the
guard body to 180
°,
finally tighten
the fastening screw (Fig1 & Fig2).
Installing or removing grinding
wheel
CAUTION:
•
When using an abrasive cut-off
wheel, be sure to use only the sup-
plied wheel guard, inner flange,
and outer flange designed for use
with cut-off wheels.
1. Mount the inner flange onto the
spindle. Fit the wheel/disc on the
inner flange and screw the outer
flange onto the spindle (Fig 3).
2. To tighten the outer flange, press
the shaft lock firmly so that the
spindle cannot revolve, then use
the lock nut wrench and securely
tighten clockwise (Fig 4).
3. To remove the wheel, follow the
installation procedure in reverse.
NOTICE:
The groove of INNER FLANGE
must align the flatness of spindle
when you install the wheel and
tighten enough.
Side grip (Fig 5).
CAUTION:
Always be sure that the side grip is
installed securely before operation.
Screw the side grip securely on
the position of the tool as shown in
Fig5.
Hold the side grip firmly by hand to
better control the tool.
Switch Action (Fig 6).
CAUTION:
• Before plugging in the tool, always
check to see that the switch trigger
actuates properly and returns to
the “OFF” position when released.
• Switch cannot be locked in “ON”
position for safety of operator
during use. Apply caution when
using tool and maintain firm grasp
on tool.
Fig6
