Dialogic BN500IP, Руководство по установке и настройке, Страница: 13 / 46

Tasks for Installing and Configuring a Dialogic
®
BorderNet™ 500 Gateway
Page 13
WAN Configuration
Using this configuration, the BorderNet 500 Gateway is connected to an outside network on one network interface
and your firewall on another network interface. Only data will be sent between these two interfaces. Other
network interfaces can be connected directly to your LAN, DMZ, or other networks. SIP traffic will be sent through
these other interfaces.
Tasks for Installing and Configuring a Dialogic
®
BorderNet™ 500 Gateway
The following table describes the required tasks for installing and configuring a BorderNet 500 Gateway:
Task Description For More Information, see
1 Install the BorderNet 500 Gateway software. Installing the Dialogic
®
BorderNet™ 500 Gateway Software on
page 14.
2 Activate the BorderNet 500 Gateway licenses. Activating Licenses on page 19.
3 Understand the overall BorderNet 500 Gateway
configuration process. Overview of Configuring the Dialogic
®
BorderNet™ 500 Gateway
on page 22.
4 Access the SIParator web interface. Accessing the SIParator Software Web Interface Directly from a
Browser
on page 22.
5 Set up access to the configuration, including
setting up the network interfaces and setting up
access control. Setting Up Access to the Dialogic
®
BorderNet™ 500 Gateway
Configuration on page 24.
6 Specify the Siparator type. Specifying the SIParator Type on page 26.
7 Configure basic SIParator services. Configuring Basic SIP Services on page 27.
8 Configure SIP sessions and media services. Configuring SIP Sessions and Media Services on page 28.
9 Configure SIP Interoperability. Configuring SIP Interoperability on page 29.
10 Configure SIParator routing, including creating a
dial plan. Configuring SIParator Routing on page 30.
11 Apply the SIParator configuration. Applying the SIParator Configuration on page 35.