Dialogic 2000 Media Gateway Series, Быстрый старт

Страница: 3 / 4

Setting T1/E1 Parameters
Navigate to: Configuration > TDM > T1/E1 and adjust the following settings -
1.
Set
Telephony Port Interface Side
: This should be Terminal if your PBX is set to Network or Network if your PBX is set to Terminal.
2. Set line Encoding and framing : This should match your PBX settings.
3. Click Submit to save settings. This will prevent loss of configuration. Do not restart the gateway.
Navigate to: Configuration > TDM > General
and adjust the following settings -
1.
Set
PCM Coding:
uLaw or aLaw to match your PBX setting.
2.
Click Submit to save settings. This will prevent loss of configuration. Do not restart the gateway.
Setting Microsoft
®
Office Communications Server 2007 Specific Parameters
Navigate to: Configuration > VoIP > General , and adjust the following setting -
1. Set Transport Type : TCP.
2.
Click
Submit
to save settings. This will prevent loss of configuration. Do not restart the gateway.
Navigate to: Configuration > VoIP > Media , and adjust the following settings -
1. Set Audio Compression : G.711u or G.711a to match your Microsoft
®
Office Communications Server 2007 setting.
2. Set Signaling Digit Relay Mode : Off.
3. Set Voice Activity Detection : Off.
4.
Set
fax IP-Transport Mode
: G.711-Passthrough.
5.
Click Submit to save settings. This will prevent loss of configuration. Do not restart the gateway.
Navigate to: Configuration > IP , and adjust the following setting -
1. Set BOOTP Enabled : No.
2. Click Submit to save settings. This will prevent loss of configuration. Do not restart the gateway.
Set Telephony Port Interface Side to
Network or Terminal, using the opposite
setting from your PBX setting
Set Transport Type : TCP
Set
line Encoding
and
framing
to match
your PBX settings
Set Audio Compression
: G.711u or
G.711a to match your Microsoft ® Office
Communications Server 2007 setting
Set Signaling Digit Relay Mode and
Voice Activity Detection : Off
Set fax IP-Transport Mode : G.711
Passthrough
Set BOOTP Enabled: No
Set PCM Coding : uLaw or aLaw to
match your PBX setting