Document No: 9100-127-1835-99 Rev C
Page 3 of 5
1501 Route 34 South, Farmingdale, NJ 07727
Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com
Connect power cable conductors as follows:
o
Green wire connects to Safety Ground.
o
White wire connects to Neutral
o
Black wire connects to Live
o
When using 208V (two 120V phases) connect the black wire to one phase and the white
wire to the other phase.
Since the light fixture does not have an internal fuse on the white wire (as it is
normally the neutral), a fuse may be connected in series with the white wire if
required.
Restore power and verify operation.
Interfacing to an Occupancy Sensor:
This light fixture is ideally suited for control by an occupancy sensor in order to maximize energy savings
based on its instant-on behavior and low power consumption. Instructions for connecting the fixture to an
occupancy sensor are listed below.
WARNING
: TO BE INSTALLED AND/OR USED IN ACCORDANCE WITH APPROPRIATE ELECTRICAL
CODES AND REGULATIONS.
WARNING
: CONTROLLING A LOAD IN EXCESS OF THE SPECIFIED RATINGS OF THE
OCCUPANCY SENSOR COULD DAMAGE THE UNIT AND POSE RISK OF FIRE, ELECTRIC SHOCK,
PERSONAL INJURY, OR DEATH. CHECK LOAD RATINGS TO DETERMINE THE UNIT’S SUITABILITY
FOR YOUR APPLICATION.
WARNING: TO AVOID FIRE, SHOCK OR DEATH, TURN OFF POWER AT CIRCUIT BREAKER
OR FUSE AND TEST THAT THE POWER IS OFF BEFORE WIRING.
Install occupancy sensor as per sensor instructions to provide desired coverage of area.
Connect luminaire wires per wiring diagram as follows: Black lead to load of the occupancy
sensor, White lead to the line (neutral), Green lead to earth ground. Multiple fixtures may be
connected to a sensor, as long as the rated load of the sensor is not exceeded.
Restore power at circuit breaker or fuse.
Verify operation of system. If the light will not turn on, check the operation of the fixture and
sensor individually, and check that the wiring is done correctly. If the light will not turn off, or it
turns off and on quickly, see the sensor’s installation instructions for further guidance.
