40
GB
■
Allocating a motion detector to a group
The group 1 detectors are factory-set to normal sensitivity (DM220W) or
maximum sensitivity (DM320W).
These settings can be modified in accordance with the table below.
The 3
rd
digit of the code allows the sensitivity to be set:
- for maximum sensitivity:
obligatory
with the DM320W detector.
- for normal sensitivity: recommended with the DM220W detector.
➀
Assign the detector the chosen group by programming the relevant code
0
1
Active when Part Set
and Fully Set
Alarm triggered
immediately
Active when Group 1 Set
Alarm triggered
immediately
Maximum
Normal
Group 1
or
Group 1
immediate
Active when Part Set
and Fully Set
Alarm triggered
immediately or with delay
Active when Fully Set
Inactive when Part Set
Alarm triggered
immediately
Active when Fully Set
Inactive when Part Set
Alarm triggered
immediately or with delay
Active when Group 1 Set
Alarm triggered
immediately or with delay
Active when Group 2 Set
Alarm triggered
immediately
Active when Group 2 Set
Alarm triggered
immediately or with delay
Group 2
or
Group 1
delayed
Group 3
or
Group 2
immediate
Group 4
or
Group 2
delayed
Group
Motion detector function
Base unit in
Part set/Fully set
mode
0 0 0 0
0 0 1 0
Maximum
Normal
0 1 0 0
0 1 1 0
Maximum
Normal
1 0 0 0
1 0 1 0
Maximum
Normal
1 1 0 0
1 1 1 0
Code for
selected group
Sensitivity
selected
Base unit in
indepen-
dent groups
mode
Start
programming
by pressing
both keys
simultaneously
until the indicator
light goes out.
Press both keys
simultaneously
again until the
indicator light
goes out.
Confirm the
programming
by pressing both keys
simultaneously until
the indicator light goes
out. The indicator
light will come on for
5 seconds to indicate
the programming
has been successful.
Enter the sequence
of
4 short key
presses
corresponding
to the number
of the detector you
are programming.
0
1
0
1
0
1
