5
11
.
TROUBLESHOOTING
Malfunction
Nebuliser does
not start
Appliance is too
loud
There are drops of
water in the
tubing
Probable cause
The main switch of the
compressor is off.
No filter in the appliance
Nebuliser was not cleaned
after previous use.
The tubing is bent.
The filter is blocked.
No medication.
Too much medication was
inserted.
The tubing was not dried.
Solution
Switch on the appliance.
Place the filter inside the appliance.
Clean the appliance.
Remove all bents or knots found along the
tubing.
Replace the filter.
Add an appropriate amount of the medication
prescribed by the doctor, to the medication cup.
Adjust medication amount in the cup to the
appropriate level, connect the tubing to the
compressor and switch the appliance on.
Moisture left in the tubing may be removed by
starting the appliance for a few minutes without
connecting the nebuliser. If the tubing is dirty,
replace it with a clean one.
12.
SYMBOLS USED
Important
warnings
Alternating
current
Manufacturer
Year of
production
Last
revision
date
Serial
number
Catalogue
ref. number
Safety fuse
Rev.
SN
Insulation
class II
BF device
IP21
Read the
instruction
manual
Protect
from
moisture
International
Protection
(IP) code
NOTE!
Portable wireless communication devices may interfere with ELECTRICAL MEDICAL DEVICES.
Operation near (in the distance of 2.8 m) a mobile phone is likely to cause malfunction
of stimulator's output.
NOTE!
Technical data required by this standard are available at
http://www.diagnosis.pl/norma-en-60601-1-2.html
Dispose of the used product at the waste collection venue. It contains components dangerous to
the environment. Proper disposal of the appliance guarantees preservation of valuable resources
and avoidance of negative impact on health and the environment that is likely to be threatened
due to improper waste disposal.
Rev. 2016.09.13
przygotowana na podstawie polskiej wersji językowej z dnia 2015.09.01
an
Содержание Bobo-neb
Страница 7: ...NOTES...
