CAUTION: Be sure ram will clear material gauges
before operating machine.
SETUP
A. Change size of tab (set at factory for 1/2” tab)
Loosen bolts (A) holding lower blade to blade
carrier (do not remove).
Slide blades forward or back, holding them
against shoulder machined in blade carrier to
obtain desired tab.
Tighten bolts (A).
Loosen bolts (B).
Lower ram until upper blades pass by lower
blades (it may be necessary to slide one upper
blade back).
Slide blade (C) forward into notch in lower
blade. Tighten bolts.
Slide blade (D) forward until it contacts blade
(C). Tighten bolts.
(Note: A slight opening at (H) is normal to insure
contact at cutting edge.)
1.
2.
3.
4.
5.
6.
7.
B. Setting size of notch
Loosen screws (G) and set to required notch
depth, reading scale along edge (E).
Note: Scale is set to read from the edge of the
notch so tab size must be subtracted to obtain
a corner notch of equal depth.
To notch along the side of a sheet, remove
gauges and turn them upside down. Screws will
fit in outside slot when gages are set parallel to
each other.
1.
2
.
C. Shearing long strips full width
Remove lower left blade and adjust right blade
to maximum tab size.
1.
D. Setting depth of stroke
With power off, step on foot pedal and turn
flywheel by hand until ram is at bottom of
stroke.
Remove pin (N) and loosen lock nut (O)
Lower ram by hand until upper blade is 1/16”
below edge of lower blade.
Adjust connecting rod link on shaft until pin (N)
will re-enter hole. Re-tighten lock nut (O).
1.
2.
3.
4.
SETUP
B
D
A
H
B
C
A
G
E
N
O
3
