4
Version 2.0 October 2015
Den Haan Rotterdam
1. MOUNTING INSTRUCTIONS
Mounting the panel
Place the control panel inside the wheelhouse, where it is
protected against weather influences. The housing is
especially constructed to be flush mounted in an instrument
cabinet according the illustration on the right.
The minimum space needed behind the panel is 90 mm.
(depth)
Searchlight installation
Install the searchlight in a horizontal upright
position with sufficient space around the head
of the searchlight to ensure it can move freely.
The sticker on the motor housing indicates the
front of the searchlight. The dimensions can be
found on page 7.
Electrical installation
Install the electrical wiring according to the wiring diagrams of page 9 and 10.Keep the distance between
the power supply and halogen lamp as short as possible. Long wires will increase a voltage drop near the
halogen lamp, which affects the light output.
2. MAINTENANCE
Lamp replacement
1. Switch off the main power
Caution – hot lamp. Let the lamp cool down for at least 10 minutes before proceeding maintenance.
2. Open the drum
3. Remove the lamp from the lampholder
4. Ensure that the replacement lamp is of the same type
5. Take a clean cloth to place the new lamp
Do not touch the lamp with bare fingers, remove any fingerprints with a cloth and alcohol and rub it dry
6. Check the neoprene sealing of the front glass and rub it in with talcum powder
7. Close the drum
8. The searchlight is ready for use
Preventive maintenance
Clean the searchlight with clean water regularly. Do not use any aggressive cleaning agents.
90 mm
90 mm
Cut-out panel
15°
30°
150 - 220
352 - 390
ø131
ø201
3 x M6
3 x 8,5
Warning!
Den Haan Rotterdam accepts no responsibility for any damage if the searchlight is installed
incorrectly and/or used improperly. When in doubt consult a qualified electrical technician.
!
