DHR 230RCB Series, Техническая документация

Страница: 6 / 24

6
Version 1.1 January 2019
Den Haan Rotterdam
1. MOUNTING INSTRUCTIONS
Mounting the panel
Place the control panel inside the wheelhouse, where it is protected against weather influences. The panel
has been designed in order to be flush-mounted in an instrument cabinet, as shown in the illustration below.
The minimum space needed behind the panel is 110 mm. (depth)
97 ± 1 mm
97 ± 1 mm
Cut-out panel
Searchlight installation
Install the searchlight in a horizontal upright position with sufficient space around the head of the searchlight
to ensure it can move freely. The dimensions can be found on page 9.
Bolt M10x (60 + M)
Insulation sleeve
Lantern base
Insulation sleeve
Washer M10
Mounting plate Min. 5 mm
Nut M10
M
All dimensions in mm
Fasteners
• The permissible torque should be 8 Nm
• Use only A4-grade stainless steel
Caution!
Even though the housing is made of corrosion resistant materials, galvanic corrosion may still occur. To
prevent galvanic corrosion use the supplied insulation sleeves to isolate the aluminium housing from
other metal parts.
4 x Ø10
162,5
162,5
Warning!
Den Haan Rotterdam does not accept responsibility for any damage if the searchlight is in-
stalled incorrectly and/or used improperly. When in doubt consult a qualified electrical techni-
cian.
!