Dhollandia DH-S Series, Руководство по установке

Страница: 36 / 82

35
DHOLLANDIA
10.2 CHECK THE POSITION OF THE TOOTH RACK OF THE RETRACTION SYSTEM
•
The aluminium sliding tubes are delivered with the tooth racks in a
standard position that works for the majority of applications.
•
When sliding onto the lift frame and sliding plates for the first time,
make sure that the tooth rack covers the minimum range (TR) [see
Figure 10.8]. Slide the tubes from the platform work position to the
stowing position.
•
The range TR should overlap the gear wheel both in working and
stowing position. This will prevent the gear wheel running off of the
tooth rack. [Figure 10.8]
•
If this is not the case, loosen the bolts that fix the tooth rack to the
sliding tubes, re-adjust the position of the tooth racks, and fasten
them again to the required torque.
•
Make sure the 2 tooth racks take the same position in comparison
to their corresponding gear wheel. [Figure 10.6]
•
Push the 2 square bars [1 and 2 in Figure 10.7] firmly against their
respective slide plate and fasten them together by means of a
locking bolt M8.
❸
1x M8
Figure 10.6
Figure 10.7
Figure 10.8
❶
❷
❸