Dhollandia DH-S Series, Руководство по установке

Страница: 10 / 82

9
DHOLLANDIA
6 LIFTGATE TERMINOLOGY
6.1 DH-S* LIFTGATE TERMINOLOGY
See [Figure 6.1] on next page for parts corresponding to numbers in this table
# Description
1 Platform Assembly : combination of the main and flip sections of the platform.
2 Platform, Main Section : inboard section of the foldable platform. Manufactured from steel or lightweight aluminium, with a
permanent non-slip working surface.
3
Platform, Flip Section : carries the load during loading / unloading, lifting / lowering. Consists of a platform main section and a
flip-over point.
4 Platform Pitch Adjustment bolts : bolts that adjust the angle of the main and flip section of the platform.
5 Platform Knuckle Assembly : assembly responsible for allowing the platform to pivot.
6 Lift Arm Weldment : support brace between the parallel lift arms.
7 Lifting Cylinder : hydraulic cylinders used to LIFT / LOWER the lift arms, the platform and its load.
8
Tilt Cylinder : hydraulic cylinders used to control the pitch of the lift platform.
9 Mounting Brackets : used to mount the sliding tubes to the vehicle chassis.
10 Sliding Tube : steel channels mounted to the underside of the vehicle body allowing the platform to slide.
11 Slide Plate : used to mount the lift frame to the sliding tubes.
12
Lift Frame: box beam connecting all main lifting components.
13 Gear Wheel and Tooth Rack : actuates the sliding function of the platform.
14 Auto Tilt Brackets (L+R) : allow the platform to pitch downward and become level with the loading surface.
15 Hydraulic Power Unit: contains the electric motor driving the hydraulic pump, the oil tank, and the control valves.
16 Control Box : contains control buttons used to operate the lift.
17 Center point of maximum load : point up to which the maximum rated capacity of the liftgate is valid. Beyond that point, the
maximum safe working load diminishes according to the applicable load charts.