Dhollandia DH-RM.25, Руководство по установке, Страница: 47 / 79

46
DHOLLANDIA
15 MOUNTING OF THE SIDE STEPS & DOCK BUMPERS
1. There are 2 possible set-ups [see also drawings in appendix]:
I. Side steps directly bolted to floor extension plate by means of 2 bolts M16 [1 in Figure 15.1], to obtain 2440mm overall
width (for 2130mm platform width).
II. Side steps with intermediate mounting blocks [2 in Figure 15.1], bolted together in 2 subsequent steps by means of 2+2
bolts M16 [1+2 in Figure 15.1] to obtain 2590mm overall width (for 2310mm platform width).
2. Bolt the side steps to the floor extension as shown. If a 2590mm extension kit is specified, install the extension kit [far right in
Figure 15.1] before mounting the side steps.
3. Maintain a 90° angle between the steps and the extension plate. [Figure 15.2]
4. Fasten all bolts and locking nuts to the required torque settings.
Figure 15.1
Figure 15.2
5. Weld the support channels to the rear sill and underside of the I-beam cross members [Figure 15.3]. Weld to as many I-beam or
cross members as possible, to distribute the forces of dock impact as much as possible.
Per side
❶
2x M16x2 (8.8) 195 Nm 143 lbs-ft
❷
2x M16x2 (8.8) 195 Nm 143 lbs-ft
❶
❶
❷