Dhollandia DH-RM.25, Руководство по установке, Страница: 30 / 79

29
DHOLLANDIA
Figure 10.5

Alternatively, the mounting plates may be welded to the chassis rails instead of bolted. When doing so, observe the precautions
regarding welding on galvanized steel on page 25.

Make min. 6 pcs. 10mm welds, min. 102mm long, evenly spread around the periphery of the mounting plates (per plate). [

Figure 10.5].

When there is an overlap between the mounting plates and the long sills, make min. 2 pcs. 10mm welds, min. 102mm long, at the
top of the mounting plates (per plate). [Figure 10.5]

If there is no overlap, add a connection plate to extend the height of the mounting plate, overlap the long sills, and make min. 2
pcs. 10mm welds, min. 102mm long, at the top of the mounting plates (per plate). Apply equivalent welds to join the mounting
plate with the connection plate. [Figure 10.6]
WARNING

During installation, the bolts and nuts should be fastened to the proper torque, shown in these installation instructions.

If you use mounting bolts not supplied by DHOLLANDIA, make sure the total strength is at least equivalent as per this manual.

Check and retighten the bolts after static and dynamic load tests performed at the end of the installation process.