audioShare Control Relay Module Installation Guide v00r01-090421.wpd
6
Mechanical Installation
Tools Required
The following tools are required for the installation of various
audioShare
®
devices:
• Phillips Screwdriver - small tip
• Wire Stripping Tool for Cat. 5 wire preparation.
• Crimping Tool for RJ45 connector installation.
• Ethernet Cable Tester for Cat. 5 cable and RJ45 connector installation checking.
• Various pliers, wire cutters and screwdrivers.
• Multi-Meter (DMM or mechanical movement) with DC Volts, Resistance and Continuity
functions.
CAUTION:
Before installing any
audioShare
®
units or accessory modules, make sure the
power supply is disconnected to prevent accidental damage to the units and to prevent the
possibility of electrical shock.
WARNING:
It is common practice to acid wash exterior brick or stone walls or to power
wash homes with siding or stucco exteriors. Doing this with an
audioShare
®
CRM exposed
to the wash will damage the unit. Resulting damage is not covered under the warranty.
Always be sure to remove the unit and protect the Cat 5 wires and the RJ45 connectors
before performing these washes.
The CRM should be installed where it will be protected from weather, excessive heat and moisture,
and tampering by unauthorized persons. There are no particular orientation issues. The unit is
completely self-contained and is powered from the main
audioShare
®
system power supply via the
Cat.5 (or other) cable.