Configuring Advanced Settings / Processing Images
Imprinting Thicker (Taller) Material
To imprint material thicker than 70 mm (2.8 in.), remove the base unit.
"
IMPORTANT
The imprinting position alignment accuracy will be lower compared with using the base unit. Perform a test
imprint and fine-adjust the position before imprinting for production.
Procedure
A
If the base unit is mounted on the machine, remove it.
"
P.37 "Installing/Removing the Base Plate"
B
Mount the material so that the surface to be imprinted fits within the imprintable area.
Secure the material, and adjust the imprint height.
"
C
Switching On the Power
"
D
Press the Power/Movement button.
Lower the head to a position where it can detect the material height.
IMPORTANT
If the material height does not meet the conditions, an error will occur and the [Power/Movement] button will
blink. Reload the material in a way that is suitable for the height.
"
P.42 "Preparing the Material", P.60 "Mounting the Material", P.118 "Was the material set in a way that is suitable
for the material thickness (height)?"
E
Press the Power/Movement button again.
The head moves to the left rear.
F
Press the laser pointer button.
The laser pointer is irradiated. Adjust the position of the material so that laser pointer points at the
center of the area to be imprinted on the material.
To continue, refer to P.66 "Making Imprints" and imprint.
We recommend carrying out a test imprint to verify the position.
2
Imprinting
106
