DGSHAPE METAZA MPX-95, Руководство пользователя

Страница: 120 / 142

118
Troubleshooting
The [Power/Movement] Button Is Blinking.
Did you switch on the power
with the height of the head
position is fixed?
If the power is switched on while the height of the head position
is fixed, the initial operation is stopped. If the machine continues
the initial operation while the material is loaded, the material sur-
face may be scratched and/or the marking pin may be damaged.
Loosen the knob counterclockwise once. Then, while pushing
the head's stopper against the ring, tighten the knob. Press the
[Power/Movement] button to complete the initial operation,
causing the lamp to stop blinking and light up.
Ring
Stopper
Tighten Loosen
Tighten Loosen
The center of the knob must be positioned
immediately above the top of the triangle.
If you’re not using a head
cap, did you forget to adjust
the height of the head posi-
tion?
The tip of the head hits the surface of the material. Switch off
the power by holding down the [Power/Movement] button for
one second or longer.
When imprinting without using the head cap, adjust the head
position to an appropriate position based on the surface height
of the material and secure the head firmly with the knob. If the
head is fixed at the position that is lower than the surface height
of the material, the tip of the head hits the surface of the material.
P. 60 "Mounting the Material"
Do you lift the head when you
turn ON the power?
Because the head is lifted to the topmost, the machine deter-
mines that the surface height of the material does not meet the
requirements for carrying out imprinting. Switch off the power
by holding down the [Power/Movement] button for one second
or longer.
When switching on the power, be careful not to touch the head
unnecessarily.
Is a change in the height of
the imprint surface too tall?
Switch off the power by holding down the [Power/Movement]
button for one second or longer. Check the conditions of imprint-
able materials and select a material again.
P. 42 "Preparing the Material"
Was the material set in a
way that is suitable for the
material thickness (height)?
Switch off the power by holding down the [Power/Movement]
button for one second or longer.
The height that can be imprinted and the material surface height
do not match. Because the setting method varies depending on
the material thickness (height), reload the material in a way that
is suitable for the height.
P. 60 "Mounting the Material"
4
Trouble
-
shooting