DGS - 17 Lucienne Ave. Danielson, CT 06239 - 800-932-3339 - [email protected]
Please visit gymsupply.com for product assembly videos.
BACK
SIDE VIEW
Cut at middle
1-1/4” Deck Screws
x2
x2
Secure pulleys to top of salmon ladder using 1-1/4” deck screws, to
the top of the salmon ladder, being sure that the longer side of the
pulley arm faces the side of the ladder with peg holes.
Secure pads to back side of salmon ladder using 1-1/4” deck screws,
being sure to leave a 2” space between the pad and upright for the
weights and rope to slide behind.
Unwrap rope and pull taught. Measure to the center of the rope
and cut in the middle, leaving one length of rope extending from
each side of the bar.
Thread cut end of rope over pulley on long side first, then short
side, so that the rope hangs down towards the pad on the back of
the salmon ladder upright.
Tie weights on to end of each side. Start with two weights and
adjust if needed with more or less depending on desired bar
action after release. Test bar and weight action before cutting
ropes down to desired lengths.
Weights should slide freely behind pads on back of salmon
ladder uprights.
Weights
Weights
SALMON LADDER PULLEY SYSTEM
SIDE VIEW
1-1/4”
Deck
Screws
SALMON LADDER BAR
