DG SATA-IP, Инструкция, Страница: 4 / 10

dg_sata_ip_dev_demo_instruction_at7_en.doc
17-Jun-21 Page 4
9. Download and program configuration file and firmware to AC701 by using Vivado tool, as
shown in Figure 2-5.
Figure 2-5 Programming configuration file
10. After FPGA starts operation, check GPIO LEDs status on AC701 board at LED0-LED1
that must be ON, as shown in Figure 2-6. Each LED description is described in Table 2-1.
Figure 2-6 LED status after system set up complete
Table 2-1 LED Status of device reference design on AC701 board
LED ON OFF
LED0 OK 150 MHz of SATA clock on CLKSMA cannot lock.
Please check 150 MHz clock source on CLKSMA board.
LED1 OK SATA-IP cannot detect SATA-II host (PC).
Please check SATA-II host and the connection.
LED2 Always OFF
LED3