dg_sata_ip_dev_demo_instruction_at7_en.doc
17-Jun-21
Page 1
SATA-IP Device Demo Instruction on AC701
Rev1.1
17-Jun-21
This document describes SATA-IP Device evaluation procedure on AC701 using SATA-IP Device
reference design bit-file. This design support fixed SATA-II speed.
1 Environment Requirement
To run the demo on FPGA development board, please prepare following environment
1. Xilinx Artix-7 FPGA AC701 Evaluation Kit
2. PC which supports SATA-II speed for connecting with SATA-II storage.
3. PC with installing Xilinx programmer software (Vivado) and SATA device connector on PC.
Note: Serial console software such as HyperTerminal or TeraTerm for optional to monitor
status. Set baud rate=115,200 / data=8bit / Non-Parity / Stop=1bit.
4. AB02-CROSSOVER with SATA standard cable to be SATA crossover cable
5. AB10-PATAFMC to be SATA connector of AC701 board
6. AB14-CLKSMA to be clock generator for SATA application
Note: AB02-CROSSOVER, AB10-PATAFMC, and AB14-CLKSMA are provided by Design
Gateway
7. micro USB cable for programming FPGA, connecting between FPGA board and PC
8. (Optional) mini USB cable for Serial console, connecting between FPGA board and PC
Figure 1-1 SATA device demo test environment