www.dfi.com
Chapter 1 Introduction
28
ACPI Configuration
Wake System from S5 via RTC
When Enabled, the system will automatically power up at a designated time every day.
Once it’s switched to [Enabled], please set up the time of day — hour, minute, and
second — for the system to wake up.
State After G3
Select between S0 State, and S5 State. This field is used to specify what state the
system is set to return to when power is re-applied after a power failure (G3 state).
S0 State
The system automatically powers on after power failure.
S5 State
The system enter soft-off state after power failure. Power-on signal input
is required to power up the system.
Last State
The system returns to the last state right before power failure.
Wake up time
When Wake On RTC is set to enabled, specify the wake up time of the day: <hour>
(00~23), <minute> (00~59), <second> (00~59).
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/- : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
Version 2.20.1275. Copyright (C) 2020 American Megatrends, Inc.
Advanced
Enable or disable System
wake on alarm event. When
enabled, System will wake
on the hr::min::sec speci
-
fied
RC ACPI Configuration
Wake system from S5 via RTC
State After G3
[Disabled]
[S0 State]
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/- : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
Version 2.20.1275. Copyright (C) 2020 American Megatrends, Inc.
Advanced
Enable or disable System
wake on alarm event. When
enabled, System will wake
on the hr::min::sec speci
-
fied
RC ACPI Configuration
Wake system from S5 via RTC
Wake up hour
Wake up minute
Wake up second
State After G3
[Enabled]
0
0
0
[S0 State]
