www.dfi.com
Chapter 3 Hardware Installation
12
Chapter 3
System Memory
Standby
Power LED
The system board is equipped with two 204-pin SODIMM sockets supporting up to 16GB
system memory and dual channel DDR3L 1600MHz memory interface.
DDR3L_1
SODIMM
Important:
Electrostatic discharge (ESD) can damage your board, processor, disk drives, add-in
boards, and other components. Perform installation procedures at an ESD workstation
only. If such a station is not available, you can provide some ESD protection by wear-
ing an antistatic wrist strap and attaching it to a metal part of the system chassis. If
a wrist strap is unavailable, establish and maintain contact with the system chassis
throughout any procedures requiring ESD protection.
Important:
When the Standby Power LED is red, it indicates that there is power on the board.
Power-off the PC then unplug the power cord prior to installing any devices. Failure to
do so will cause severe damage to the board and components.
System Memory
Top View
Bottom View
DDR3L_2
SODIMM
