www.d
fi
.com
12
Chapter 2 Hardware Installation
Chapter 2
Important:
The CPU socket must not come in contact with anything other than the CPU. Avoid
unnecessary exposure. Remove the protective cap only when you are about to install
the CPU.
Installing the CPU
1. Make sure the PC and all other peripheral devices connected to it has been powered down.
2. Disconnect all power cords and cables.
3. Locate the LGA 1155 CPU
socket on the system
board.
4. Unlock the socket by push-
ing the load lever down,
moving it sideways until it
is released from the reten-
tion tab; then lift the load
lever up.
Retention tab
Load lever
6. Remove the protective cap
from the CPU socket. The
cap is used to protect the
CPU socket against dust
and harmful particles.
Remove the protective cap
only when you are about
to install the CPU.
Load lever
Load
plate
5. Lifting the load lever will at
the same time lift the load
plate.
Lift the load lever up to
the angle shown on the
photo.
Protective cap
Содержание SB332-C
Страница 1: ...www dfi com 1 Chapter 1 Introduction SB332 C Micro ATX Industrial Motherboard User s Manual A24310450 ...
Страница 66: ...www dfi com 66 Appendix E BIOS status code Appendix E PEI Beep Codes DXE Status Codes ...
Страница 67: ...www dfi com 67 Appendix E BIOS status code Appendix E ...