18
2
Hardware Installation
1. Pull the “tabs” which are at the ends of the socket to the side.
2. Position the RIMM above the socket with the “notches” in the
module aligned with the “keys” on the socket.
3. Seat the module vertically into the socket. Make sure it is
completely seated. The tabs will hold the RIMM in place.
2.2.2 Installing a RIMM
A RIMM simply snaps into a RIMM socket on the system board. Pin
1 of the RIMM must correspond with pin 1 of the socket.
The CRIMM module included in the system board package looks
similar to the one shown below..
Kap2_NT70.p65
13.12.01, 09:12
18
