20
Chapter 2 Hardware Installation
Chapter 2
USB Ports
The USB device allows data exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
The system board is equipped with four onboard USB 3.0/2.0/1.1 ports (USB 0-1/2-3) and
eight onboard USB 2.0/1.1 ports (USB 4-11). The 10-pin connector allows you to connect 2
additional USB 2.0/1.1 ports (USB 12-13). The additional USB ports may be mounted on a
card-edge bracket. Install the card-edge bracket to an available slot at the rear of the system
chassis and then insert the USB port cables to a connector.
BIOS Setting
Configure these onboard USB devices in the Advanced menu (“USB Configuration” submenu)
of the BIOS. Refer to the chapter 3 for more information.
Driver Installation
You may need to install the proper drivers in your system operation to use the USB device.
Refer to your operating system’s manual or documentation for more information.
USB 12-13
10
VCC
-Data
+Data
GND
Ke
y
VCC
-Data
+Data
GND
N. C.
9
1
2
USB 2.0
USB 1
USB 0
USB 3
USB 2
USB 9
USB 8
USB 2.0
USB 3.0
USB 10-11
USB 4-7
USB 11
USB 10
USB 5
USB 4
USB 7
USB 6
USB 2.0
Important:
If you are using the Wake-On-USB Keyboard/Mouse function for 2 USB ports, the
+5V_standby power source of your power supply must support
≥
1.5A. For 3 or more
USB ports, the +5V_standby power source of your power supply must support
≥
2A.
Wake-On-USB Keyboard/Mouse
The Wake-On-USB Keyboard/Mouse function allows you to use a USB keyboard or USB mouse
to wake up a system from the S3 (STR - Suspend To RAM) state. To use this function:
• Jumper
Setting
JP4, JP5, JP8 and JP11 must be set to “2-3 On: +5V_standby”. Refer to “USB Power Select” in
this chapter for more information.