2
48
Hardware Installation
2.8.17 Wake-On-Ring Connector
Pin
1
2
Function
Ground
RI#
The Wake-On-Ring connector is used to connect to an internal
modem card that has the same connector. It will allow the system
that is in the Suspend mode or Soft Power Off mode to wake-up/
power-on to respond to calls coming through the internal modem
card.
To use this function, connect one end of the cable (that came with
the card) to the card’s wake-on-ring connector and the other end to
location J5 on the system board. You must also enable the “Resume
on Ring” field in the Power Management Setup of the BIOS.
If you are using an external modem, the ring-on function will come
through the serial port where the external modem is connected.
Important:
If you are using a modem add-in card, the 5VSB power source
of your power supply must support
≥
720mA.
