DFI G586IPBS, Руководство пользователя

Страница: 37 / 44

G586IPBS
33
Installing Upgrade CPUs
The G586IPBS is equipped with a 321-pin Zero Insertion
Force (ZIF) socket at location U31 of the system board. This
socket is designed for easy removal of the old CPU and easy
insertion of the upgrade CPU. The socket allows you to
carefully place the new CPU into its position. If you need to
apply excessive force to insert the CPU, the installation is
being done incorrectly.
Warning:
Open the socket only if actually installing a CPU. The
warranty on the original CPU will be voided if the S/N seal
is broken.
Do not change any factory CPU speed jumper settings. You
do not need to change any jumpers to properly install the
3.3V Pentium Upgrade Processor.
Before proceeding with the upgrade, take note of the
following. The microprocessor and heat sink may be hot if
the system has been running. To avoid the possibility of a
burn, power the system off and let the processor and heat
sink cool for 10 minutes.
The 321-pin ZIF socket consists of the five rows of pin holes
on each side. To prevent improper OverDrive Processor
installation, the ZIF socket has a Plug/Keying mechanism.
Several holes in the socket are plugged so OverDrive
Processors will go in only one way. If you cannot easily
insert the OverDrive Processor, verify that pin 1 of the CPU
is aligned with pin 1 of the socket. A warning note — be
extremely careful to match pin 1 of the CPU with pin 1 of
the socket. Only Intel's OverDrive Processor is keyed to
prevent improper placement in the ZIF socket. Other Intel
CPUs, as well as CPUs from other vendors, can be placed
incorrectly and will be permanently damaged.