DFI EL620-C, Руководство пользователя

Страница: 64 / 120

64
3
BIOS Setup
Super IO Configuration
This section is used to configure the I/O functions supported by the onboard
Super I/O chip.
Parallel Port Address
Allows you to manually select an I/O address for the onboard serial port.
Parallel Port Mode
The options are Normal, EPP, ECP and ECP+EPP. These apply to a standard
specification and will depend on the type and speed of your device. Refer to
your peripheral’s manual for the best option.
Normal
Allows normal speed operation but in one direction only.
“ECP (Extended Capabilities Port)”
Allows parallel port to operate in bidirectional mode and at a speed faster
than the normal mode’s data transfer rate.
“EPP (Enhanced Parallel Port)”
Allows bidirectional parallel port operation at maximum speed.
If you selected EPP, the “EPP Mode Select” field is configurable. If you se -
lected ECP, the “ECP Mode Use DMA” field is configurable. If you selected
ECP+EPP, both “EPP Mode Select” and “ECP Mode Use DMA” are configurable.
Parallel Port IRQ
Select an IRQ for the parallel port.
BIOS SETUP UTILITY
v02.61 (C)Copyright 1985-2006, American Megatrends, Inc.
←
Select Screen
↑↓
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Advanced


Configure WIN627DHG-P/F81217U Super IO Chipset
Parallel Port Address
Parallel Port Mode
Parallel Port IRQ
PWRON After PWR-Fail
Serial Port1 Address
Serial Port1 IRQ
Serial Port2 Address
Serial Port2 IRQ
Serial Port3 Address
Serial Port3 IRQ
Serial Port4 Address
Serial Port4 IRQ
Serial Port5 Address
Serial Port5 IRQ
Serial Port6 Address
Serial Port6 IRQ
Serial Port7 Address
Serial Port7 IRQ
Serial Port8 Address
Serial Port8 IRQ
[378]
[Normal]
[IRQ7]
[Off]
[3F8]
[4]
[2F8]
[3]
[3E8]
[4]
[2E8]
[3]
[2F0]
[4]
[2E0]
[3]
[2D8]
[4]
[2D0]
[3]
Allows BIOS to Select
Parallel Port Base
Addresses.