DFI CS35-EC, Руководство пользователя

Страница: 59 / 92

2
Hardware Installation
59
1. ATX-SW (ATX Power Switch) - Depending on the setting in the “Soft-Off By
PWR-BTTN” field in the Power Management Setup, this switch is a “dual
function power button” that will allow your system to enter the Soft-Off or
Suspend mode.
2. When the system is in the S1 (POS - Power On Suspend) state, the Green
LED and Power/Standby LED will blink every second.
3. When the system is in the S3 (STR - Suspend To RAM) state, the Power/
Standby LED will blink every 4 seconds.
4. If a system did not boot-up and the Power/Standby LED did not light after it
was powered-on, it may indicate that the CPU or memory module was not
installed properly. Please make sure they are properly inserted into their
corresponding socket.
1: HDD LED Power
2: HDD
3: N. C.
4: Green LED Power
5: Green
6: N. C.
7: PWRBT
8: Ground
9: N. C.
10: SMI
11: Ground
12: N. C.
13: H/W Reset
2.11.19 Front Panel LEDs and Switches
Diodes LED et Interrupteurs du Panneau Avant
Leuchtdioden (LED) und Regler auf der Geratevorderseite
Panet Frontal de LED y los Interruptores
Use pins 21-23 for the Power/Standby LED.
14: Ground
15: N. C.
16: Speaker Data
17: N. C.
18: Ground
19: Speaker Power
20: N. C.
21: LED Power (+)
22: N.C.
23: LED Power (-) or
Standby Signal
24: Keylock
25: Ground
English