60
3
Award BIOS Setup Utility
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC + Blank
This selection will cause the system to turn
off the vertical and horizontal synchronization
ports and write blanks to the video buffer.
Blank Screen
This option only writes blanks to the video buffer.
DPMS Support
Initializes display power management signaling.
Use this option if your video board supports it.
Soft-Off by PWRBTN
This category allows you to select the method of powering off your
system.
Delay 4 Sec.
Regardless of whether the Power Management
function is enabled or disabled, if the power button
is pushed and released in less than 4 sec, the
system enters the Suspend mode. The purpose of
this function is to prevent the system from powering
off in case you accidentally hit or pushed the
power button. Push and release again in less than 4
sec to restore. Pushing the power button for more
than 4 seconds will power off the system.
Instant-Off
Pressing and then releasing the power button at
once will immediately power off your system.
Wake Up by VGA
When set to On, the system will respond and wake up to any VGA
activity.
Wake Up by LPT & COM
Select the port you would like the system to respond and wake up
when an event occurs on that port.
Wake Up by HDD & FDD
When set to On, the system will respond and wake up to any hard
drive or floppy drive activity.
This Manual: http://www.manuallib.com/file/2504586
