DFI AGP-9800 A+, Руководство пользователя

Страница: 14 / 24

2
14
AGP-9800 Graphics Card User’s Manual
Step 5: Insert the Graphics Card
Carefully slide the graphics card into the AGP slot. When the card’s
edge-connector is aligned with the slot on the system board, press
firmly on the top of the card to seat it. Make sure the graphics card
is straight and level compared to the computer’s system board by
viewing it from the side.
Once you are satisified with its alignment, insert the slot-cover screw
on top of the bracket at the back of the graphics card.
Step 6: Replace the Computer’s Cover
When you have finished installing the graphics card, put the cover back
on your computer's system unit. Refer to your computer's system
manual for instructions if necessary.
Step 7: Connect the Monitor or TV
The graphics card can only be used with an analog video display using
a 15-pin D-shell cable connector (standard VGA monitor connection).
If your monitor supports analog video but does not have a 15-pin
D-shell connector, see your monitor dealer for the adapter or optional
cable. After you plug the monitor cable into the VGA connector of the
graphics card, gently tighten the cable screws to hold the connector in
place.
Note:
Some monitors have a switch that chooses between analog and
TTL (or digital) operation. If your monitor has such a switch, set
it for analog.
To plug a TV to the graphics card, please refer to the “Connecting
a TV to the Graphics Card” section in this chapter of the manual.
Note:
If a monitor and TV are connected at the same time, only the
monitor will work.