DeZURIK
3-20” BAW AWWA Butterfly Valves
D10386
Page 4
August 2013
Description
The 3-20” BAW AWWA Butterfly Valve is a resilient seated bi-directional valve that meets all class 150
requirements of ANSI/AWWA standard C504. Flanged and mechanical joints are offered. Pressure and
temperature ratings are shown on the valve data plate
Handling
Lifting the valve improperly may damage it. Do not fasten lifting devices to the
actuator, disc or through
the seat opening in the body. Lift the valve with
slings, chains or cables fastened around the valve
body, or fastened to bolts or
rods through bolt holes in the flanges.
Maintenance
This valve is assembled using standard SAE fasteners. To service this valve, you should have a full set
of combination wrenches, flat tipped screwdrivers, Allen wrenches, a torque wrench, sockets, chisels, a
hooked tool for removing the packing and a dead blow hammer.
Lubrication
The valve is lubricated at the factory, and does not require routine lubrication. When installing valve or if
maintenance is required, refer to the appropriate sections for lubrication requirements and use an
NSF 61 approved lubricant (such as Dow Corning 111 or Phoenix 505).
Refer to the actuator instructions for actuator lubrication requirements.
Fusion/Powder Coated Valves
Valves with fusion/powder coated exterior paint require flat washers to be installed
under the flange nuts when installing the valve to the pipeline flange to prevent the
paint from cracking or chipping.