Dexter Laundry O Series, Руководство по эксплуатации и ремонту

Страница: 13 / 68

INJECTION SOURCE CONNECTIONS
The washer control may be programmed to send ten 120VAC output signals for 60Hz models (or 24VAC
for 50Hz) for a chemical injection system. The signals are not intended as a power source and must be
limited to less than 100 milliamps of current. There is a separate terminal block for connection of the
external injection signals. For the injection sources, program codes 1 through 10 and their respective
terminal block connections are as shown in Table 1.
Table 1: Injection Signal and Circuit Identification
If required, chemical injection hoses are to be inserted into the injection inlet at the upper right rear of the
washer. These hoses should be inserted into the round PVC pipe a distance of:
For T-450 minimum of 8” (20 cm) and a maximum of 12” (30 cm)
For T-650, 750, 950 and 1450 a minimum of 14” (36 cm) and a maximum of 18” (46 cm)
(For T-350 insert hoses into the top soap dish)
This will eliminate chemical buildup in the pipe and/or restrict water flow to the tub. Secure the hoses as
required.
Fusing Requirements:
Dual element time delay fuse or equivalent breaker of amperage specified below.
• 1 Phase or 3 Phase 15 amp , 208-240v
•WN0350-12, WN0450-12.
•WN0350-39 or 59, WN0450-39 or 59.
OPERATION CHECK
During intermediate spin and final spin, the cylinder should turn in a counterclockwise direction when
viewed from the front of the machine. If spin is clockwise, the T1 and T2 motor wires connecting to
terminal T1 and T2 on the variable frequency drive should be swapped. Remove power to the machine
before opening service panels and swapping wires.
Dexter Recommended
Connections
Controller / Injector
Signals
Detergent 1
Bleach 2
Starch 3
Sour/Softener 4
5
6
7
8
9
10
24 25
Part # 8533-109-001 12/21 Part # 8533-109-001 12/21
Machine
Mounting
Installation
& Operation
Programming
Trouble-
shooting
Machine
Service
Electrical
Wiring
Parts
Data
50Hz Parts
Maintenance
Service Elec.
Compnents